Cleaning The Filters - Honeywell 17205 Serie Manual De Instrucciones

REMOVING/CHANGING THE FILTERS (continued)
Reassemble your Honeywell air purifier as described below:
1. Place the whole filter assembly into the internal chamber.
2. Replace the endcap onto the unit.
3. Reattach the locking mechanism and turn it clockwise until securely
tightened.
DO NOT OVER-TIGHTEN THE LOCKING MECHANISM.
4. Plug into a wall outlet.
5. Turn unit ON and RESET filter monitor(s) for filter(s) replaced by pressing the
appropriate filter reset button(s) for a 10 second delay (Fig. 5).

CLEANING THE FILTERS

• Turn the air purifier off and unplug from the wall outlet.
• After removing the filter assembly from the air purifier (refer
to section "Removing/Changing the Filters" in this manual),
separate and remove the carbon pre-filter from the HEPA filter
and place aside (or discard if pre-filter needs replacement).
• To vacuum-clean the filter, hold the filter and run a vacuum
cleaner with a nozzle or brush attachment along the filter to
pick-up the dirt and particles (Fig. 6). Repeat along the entire
surface of the HEPA filter.
• Note that the filter may still be discolored even after cleaning it. This is acceptable
and will not affect performance. Also, do not be concerned if you still see particles
attached to the HEPA filter. The filter performance is still optimal.
• After vacuuming the filter, wrap the pre-filter around the HEPA filter and place the
whole assembly back into the internal chamber of the air purifier (see "Removing/
Changing the Filters").
• You now need to reset the Intelli-Check
on, press and hold the appropriate filter indicator button for approximately 10
seconds until the light turns off (see Fig. 1).
If the HEPA filter clogs or if you have difficulty cleaning the filter, please visit us at
www.kaz.com or call us at 1-800-477-0457.
Filter Indicator. With the air purifier powered
™
Fig. 5
Fig. 6
5