Ferm HAM1015 Traducción Del Manual Original página 5

• C heck if the mains switch is on position "0"
before you connect the apparatus;
• K eep the main lead always away from the hot
air stream and the mouth piece;
• P ut the mains switch in position 'I or II' to let
your hot air gun operate:
"I" = 450 degrees, air flow 300 l/min.
"0" = Off
"II" = 600 degrees, air flow 500 l/min.
When the temperature is excess 600° C, the heats
switches it off automatically, however, the heater
continues to run. When the heater has cooled to
operating temperature, the heater is switched on
again.
Switching off:
Slide the switch to 0.
Tip: If you want to get the best result, test all
appliances on a little part of the workpiece.
Use of accessoires
Fig. B
Fishtail nozzle (4)
Deflects air away from glass for example when
stripping paint in window frames or softening putty.
Reduction nozzle (5)
Distributes air equally over small areas
4. MAINTeNANCe
Always disconnect the apparatus before
carrying out inspection or cleaning.
Never use water or other liquids to clean
the electrical parts of the hot air gun.
• N ever use easy inflammable liquids for cleaning
the hot air gun, especially for the mouthpiece.
• R egular maintenance of your hot air gun
prevents unnecessary problems. Keep the
ventilation slots of the hot air gun clean to
prevent overheating.
Troubleshooting
In case the hot air gun does not work well, we give
you subjoined some possible causes and their
solutions.
• T he engine gets overheated.
• T he ventilation slots of the hot air gun are dirty.
• C lean the ventilation slots.
• T he hot air gun does not start when it is
switched on.
• I nterruption in the electrical circuit.
• C heck the mains lead and the mains plug.
• T he switch is defective.
• P ull the mains lead out of the wall socket,
because there is a chance of fire risk ! Have
the hot air gun repaired at your local dealer.
• T he engine does not work, but it does heat.
• I nterruption in the electrical circuit.
• P ull the mains lead out of the wall socket,
because there is a chance of fire risk ! Have
the hot air gun repaired at your local dealer.
Faults
Should a fault occur, e.g. after wear of a part,
please contact the service address on the
warranty card. In the back of this manual you find
an exploded view showing the parts that can be
ordered.
eNVIRONMeNT
To prevent damage during transport, the
appliance is delivered in a solid packaging which
consists largely of reusable material. Therefore
please make use of options for recycling the
packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
GUARANTee
The guarantee conditions can be found on the
separately enclosed guarantee card.
5