Electrical Safety; Using The Appliance - Ferm HAM1015 Traducción Del Manual Original

circumstances;
• T he metal mouthpiece gets hot. Watch out and
do not touch the metal mouthpiece;
• P revent damage of the heating element. Do
not lock or block the mouth piece;
• D o not leave the appliance when switched on;
• D o not use the appliance for drying hair or for
drying living human beings in general;
• D o not use the appliance in a bath, above
water or in spaces where easy inflammable
liquids are used.
This appliance operates at a temperature
of 600 degrees without visible signs of
this temperature (no flames), still there is
a chance of fire risk. Watch out for the
hot air stream from the mouth piece. This
air stream can cause burns.
When operating the appliance
• I f you are going to use the hot air gun, vapours
and gas can be released during a short time.
This can be harmful for your health. Asthmatics
can suffer hindrance of it;
• B efore connecting the plug to the mains
voltage you have to check if the switch is in
position "0";
• K eep the mains lead always away from the
mouthpiece of the hot air gun;
• K eep children and animals away from the
appliance if you are using it.
Immediately switch off the appliance when:
• P lug and/or cable are defective or damaged;
• T he switch is defective;
• Y ou smell or see smoke caused by scorched
insulation from the hot air gun.

electrical safety

When using electric machines always observe the
safety regulations applicable in your country to
reduce the risk of fire, electric shock and personal
injury. Read the following safety instructions and
also the enclosed safety instructions.
Always check that the power supply
corresponds to the voltage on the rating
plate.
Class II machine – Double insulation –
You don't need any earthed plug
4
Replacing cables or plugs
Immediately throw away old cables or plugs
when they have been replaced by new ones. It is
dangerous to insert the plug of a loose cable in
the wall outlet.
Using extension cables
Only use an approved extension cable suitable
for the power input of the machine. The minimum
conductor size is 1.5 mm
reel always unwind the reel completely.

3. USING THe APPlIANCe

The Hot air gun can be used for:
• P lumbing work like tube connections, solder,
bowing tubes;
• R emoving paint, varnish and lacquer without
firerisk;
• Q uickly drying of appliances which have
become wet;
• D rying surfaces for quick repairing;
• R emoving self-adhesive labels in a clean way
placing PVC labels;
• B listering after sticking PVC materials can be
smoothed after heating;
• E asy removing of vinyl carpeting:
• F orming all synthetics with a low temperature
(450 degrees) among which polyethylene and
PVC;
• F orming all synthetics with a high temperature
(580 degrees) among which acryl and plexiglass;
• S melting synthetics, among which matters and
foils with PVC layer;
• A pplying heat shrinking tubes;
• S hrinkwrappers;
• T hawing tubes and engines;
• R epairing finishing layers: email of bath and
household appliances;
• A pplying epoxypowder coverlayers;
• R epairing of ski's, surf-boards and other
sports goods;
• U nscrewing too fast fixed screws and
connections.
Operation
Fig. A
You can work manually with this hot air gun or you
can put it in a vertical position.
. When using a cable
2