Specific Safety Advice - BGS technic 8381 Manual De Instrucciones

SPECIFIC SAFETY ADVICE

• Never exceed the max. operating pressure of 6.3 bar. The pressure can be reduced with pressure
regulator. This regulator is included.
• Keep your work space well ventilated.
• Always wear appropriate safety clothes, a respirator mask and safety goggles, when operating this
tool.
• Never point this spray gun at yourself, at others or at animals
• Make sure that no source of ignition is in your work area (e.g. open fire, burning cigarettes, non-
explosion-proof lamps etc.).
• Never spray paint into open fire, glowing surfaces or luminous elements. Atomized spray can catch
fire on open fire or hot surfaces.
• Never use oxygen or other inflammable gases as a substitute for your compressed air supply.
• Remember that cleanser, residual paint or varnish has to be recycled in accordance to
environmental laws. Check the manufacturer's safety advice for further information.
PREPARATION
After opening the packaging, check for completeness of the delivery and proper functioning of all
parts.
Connect the spray gun to your compressed air supply. Therefore connect the quick coupler of the air
hose with the inlet connector of the spray gun. To be able to adjust the air pressure, your air supply
has to be equipped with a pressure reducing regulator/valve. The operating pressure of the spray gun
is 3 – 5 bar.
The higher the air pressure, the higher is the atomization of the paint/varnish and the harder it is to
control the spray gun's output.
In case of an air pressure that's too weak, the paint will not be atomized enough to gain the best
possible result (in accordance with the viscosity and the general state of the paint). That's why we
recommend to test various air pressure adjustments until you get your desired result.
When working with varnish, the use of cleaned, condensate free and oil free compressed air is
necessary. To avoid mechanical defects and a decrease of efficiency we recommend the use of a
water drain valve. A drain valve filters all moisture out of the compressed air and catches small
particles of dust and dirt, caused by friction. This has a huge benefit on the operating life of your air
tool.
COMPONENTS
1 PP Cup
2 Paint Regulator
3 Spray Jet Regulator
4 Air Inlet (euro type quick connector)
5 Air Regulator
6 Trigger
7 Nozzle (stainless)
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed