Attaching/Detaching The Lens - Panasonic LUMIX H-NS043 El Manual Del Propietario

VQT5E43_ENG_SPA.book 7 ページ ２０１３年１２月２５日 水曜日 午後７時４１分
≥ When flash recording with a close subject, the
light of the flash will be blocked by the lens and
part of the picture may be dark. Check the
distance from the subject when recording.
≥ Operating sounds may be recorded when auto-
focusing during motion picture recording. If
operating sounds become bothersome, we
recommend setting to manual focus (MF) and fixing
focus before recording to avoid recording the lens
noise.
≥ If you set the [O.I.S.] to [ON] when recording a motion
picture, operating sounds may be recorded. If they
become bothersome, we recommend setting the [O.I.S.]
switch to [OFF] and mounting the camera on a tripod.
≥ The aperture can be adjusted with the aperture
ring only when a Panasonic digital camera is
attached to the lens. (As of January 2014)

Attaching/Detaching the Lens

Check that the camera is
turned off.
≥ Remove the lens rear cap
∫ Attaching the Lens
Align the lens fitting marks
A on the camera body and
the lens and then rotate the
lens in the direction of the
arrow until it clicks.
• Do not press the lens
release button B when
you attach a lens.
• Do not try to attach the lens when holding it at an angle to
the camera body as the lens mount may get scratched.
• Check that the lens is attached correctly.
• Be sure to remove the lens cap when recording.
∫ Detaching the Lens
While pressing on the
lens release button B,
rotate the lens toward
the arrow until it stops
and then remove.
• Attach the lens rear cap so
that the lens contact point
does not get scratched.