ARDES AR353 Folleto De Instrucciones página 13

Before connecting or disconnecting the appliance,
make certain the function selector is in the OFF
position.
To turn the appliance on, insert the plug in the power
outlet, place the switch on ON and then select the low
(I) or high (II) heating switch.
The heating switches are not independent, so in order
for the appliance to operate at the highest heating
power, the switch I must also be activated.
All the switches have an indicator light which turns on
when the switches are ON.
The appliance is equipped with a thermostat which is adjustable (Temp
Adj) only when the appliance is operating at the maximum power with
both the switches in the ON position. When the thermostat intervenes the
appliance continues to operate at half power until the room temperature
drops enough to restart the flow of hot air at maximum power.
The regulator (Dimming) can be used to adjust the luminosity of the
aesthetic front panel.
Before replacing the appliance in its package, make sure it has cooled
sufficiently.
Disconnect the plug from the socket and let the appliance cool
down well before cleaning it.
This appliance does not require any special maintenance.
In order to clean the appliance, use a soft or slight damp cloth.
Never use abrasives or chemical solvents.
Do not use very wet substances, liquids or cloths to prevent water from
entering into the appliance and irreparably damaging it.
NEVER IMMERSE THE APPLIANCE INTO THE WATER.
Replacing the lamps.
Unscrew the two screws clamping the panel located on the lower back
part of the appliance.
Replace the lamp which is not working with another having the same
technical characteristics indicated on the same.
Close the panel correctly.
Instructions for use
Maintenance
GB
GB
13