Service Department; Troubleshooting - Champion 2000 Manual Del Usuario

Tabla de contenido

Publicidad

S
P
YMPTOM
Motor will not start.
Juicer will not start unless all parts are
in position. Check screen holder sensor
located closest to motor hub for
possible damage.
Food backing up
This is normal since juicer works on
feeding chamber.
a back-pressure system.
Motor section
The motor is designed for a 40˚ heat
running warm.
rise so, depending on amount juiced,
motor will get very warm to touch.
Juice is hot.
Feeding juicer too slowly.
Possible dull cutter.
Wet pulp.
First 2 handfuls of pulp should always
be re-fed. Possible clogged screen. Turn
off the juicer, remove the screen, clean,
reassemble and continue juicing.
Juicer runs slowly.
Overloaded circuits can cause the
juicer to slow and become clogged.
The Champion
standard 110-volt, 5 amps service.
Other countries may use 220-240
volt, 50 hertz.
10
C
R
ROBABLE
AUSE AND
EMEDY
Juicer requires
2000
S
P
YMPTOM
Stuck cutter.
Lack of lubrication.
be cleaned. If cutter will not come off
with the help of a screwdriver, contact
the Service Department.
Leakage.
Some juice leakage is normal on the
juicing chamber since there are no
gaskets.
Squealing sound or
Possible motor problem. Contact the
abnormal sound.
Service Department immediately.
Clicking sound.
Juicer is being fed too rapidly. Unclog
the juicer by holding the tamper down
with one hand and apply downward
pressure on the tapered end of the
body with your other hand.
Dripping black or
Possible seal failure. Discontinue use
brown oil.
of the juicer and contact the Service
Department.

Service Department

.
ORDER PARTS AT WWW
CHAMPIONJUICER
: (209)369-2154
PHONE
:
8:30am-12noon, 1:00pm-4:30pm Pacific Time.
HOURS

Troubleshooting

C
R
ROBABLE
AUSE AND
EMEDY
Cutter needs to
OR
.
:
COM OR CALL

Publicidad

Tabla de contenido
loading

Tabla de contenido