Assembly Instructions - Champion 2000 Manual Del Usuario

Tabla de contenido

Publicidad

4

Assembly Instructions

STEP 1
Slide the cutter onto the motor shaft. Make sure the shaft is lubricated with olive oil or
coconut oil. DO NOT USE other liquid oils, butter, margarine or petroleum jelly. The
cutter may stop about 1/4-inch onto the motor shaft; rotate the cutter slightly in either
direction so the flat edge of the motor shaft will match the flat edge of the cutter hole.
It will then slide on easily.
STEP 2
Slide the body over the cutter, holding it in a horizontal position, with the feeding
chamber down.
STEP 3
Place the screen (or blank) into the recessed grooves of the body and hold it in position
with one hand. Slide the screen holder over the screen. Hold the edge of the screen
down for easier starting. The screen holder will slide over the screen only one way.
The end of the screen holder with the magnet is the starting end. Slide the screen
holder completely forward until the raised lip contacts the body slides.
Special Instructions for the Cutter
The cutter can become sticky or vacuum locked on the motor shaft. To prevent this,
we recommend applying a thin film of olive or coconut oil to the motor shaft. After juicing,
remove parts and clean them thoroughly with cold water. Do not place the cutter on the
motor shaft until you are ready to juice again. Store the cutter in a cloth or paper tow-
els to prevent injury and damage. Avoid letting water enter the shaft hole at the base of
the cutter. If water enters the hole, store the cutter vertically with the base end down.

Publicidad

Tabla de contenido
loading

Tabla de contenido