Sanyo VA-82LAN Manual De Instalación página 4

1. Installing the Option Board
1
CN806
1
2
3
Note: Arrange the two cables so as not to contact the board A.
4
3
1
CN805
A
1
Use the three supplied screws to install the
option board on the power board unit (VA-84SA
or VA-80SA)(see the figure on the left).
2
Pass the LAN cable through the cable hole and
plug it into the LAN port.
Note:
When it is difficult to plug in or pull out the LAN cable, we
recommend that you either use a LAN cable that has no plug cover
at the cable end, or displace the cover if there is one.
3
When using the voice interface, connect the two
supplied cables to the option board.
Connect the red connector cable to the CN805 (red) terminal for
voice output and the white connector cable to the CN806 (white)
terminal for microphone input. These connector cables should be
fixed firmly by wrapping once around the fixer.
4
Configure the network settings (see page 5).