Steinbach Waterpower 5000 Manual De Instrucciones página 47

- Do not start work on the heat pump before all safety instructions
have been complied with.
- Work on the heat pump may only be carried out when it is de-
energized.
- Only connect the heat pump if the mains voltage of the socket
matches that on the type plate.
- Only connect the heat pump to an easily accessible socket so that
you can quickly disconnect the heat pump in the event of a fault.
- Do not operate the heat pump if there is visible damage or if the
power cable or power plug is defective.
- If the power cable of the heat pump is damaged, it must be
replaced by the manufacturer, its customer service or a qualified
person to prevent hazards.
- Do not open the housing. Let specialists perform any repairs. All
liability and warranty claims will be void in the case of arbitrary
repairs, improper connection or wrong operation.
- Only parts that match the original device data may be used for
repairs. This heat pump contains electrical and mechanical parts
that are essential for protection against sources of danger.
- Do not operate the heat pump with an external timer or a
separate remote control system.
- Do not immerse the heat pump, power cable or power plug in
water or other liquids.
- Never touch the power plug with wet hands.
- Never pull the power cable to disconnect the power plug from
the socket. Always disconnect by holding the power plug.
- Never use the power cable as a carrier handle.
- Keep the heat pump, power plug and power cable away from
open fires and hot surfaces.
- Make sure that the power cable does not present a trip hazard.
- Do not bend the power cable or position it over sharp edges.
- Make sure that children do not put objects into the heat pump.
47