Care And Cleaning - LUND 318093 Instrucciones De Instalación

Installation Steps
Carefully slide end cap back into extrusion, ensuring rubber pads from top surface fit underneath chrome cap cover.
Push cap all the way down until all three bolt holes line up. Reinsert screws and tighten, (Figure 8).
6
Position the driver's side running board onto bracket and center on vehicle. Adjust Running Board to be parallel with
Tighten all bracket hardware, position the board accordingly, and then tighten Running Board to brackets.
Front
7
Front bracket installation pictured
Inspection After Installation
• Inspect all bolts and nuts for proper tightness.

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
• Do not use cleaning solvents of any kind.
Congratulations!
You have purchased one of the many quality Lund ® branded products offered by Lund International, Inc. We take the utmost pride in
our products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product
is top quality in terms of fit, durability, finish and ease of installation.
™
NOTE: Actual application may vary slightly from illustrations.
side of vehicle. Install (6) 5/16" flange nuts, (Figure 9 and Figure 10).
Repeat Steps 1 thru 7 for opposite side of vehicle.
Figure 9
800-241-7219 • Visit us at lundinternational.com
© 2014 Lund International, Inc. All rights reserved.
Lund and the Lund logo are trademarks of Lund International, Inc.
® ®
5/16 flange
nuts
Center bracket installation pictured
Lund International
Page 3 of 3
Figure 8
Figure 10