N'oveen CH7100 Manual De Instrucciones página 14

Calentador de convector
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 22
OPERATION
Power (CH7100/CH8000)
Insert the plug in a suitable power socket. After turn on the main switch (on the right side),
the computer board emits a "click" sound, the screen displays the current room
temperature, and turn on the panel control switch, to enter the standby state and display the
current room temperature and set temperature at the same time. In the meantime, other
displays are not displayed.
Then press the button for selecting the heat setting, you can select the
750/1250/2000W/Anti-frost four modes. When you select the mode the heater will be heated
according to your setting.
Power (CH9000)
Insert the plug in a suitable power socket. After the power is turned on, the computer board
emits a "click" sound, the screen displays the current room temperature and the set
temperature, and other displays are not displayed. At this time, other key operations are
invalid except the ON\Off key.
Press the On\Off key once to enter the standby state and display the current room
temperature and set temperature at the same time.
Timer and temperature setting
Timer (CH7100/CH8000)
Press the timer button, each time the time is increased by 1 hour, when the timer time is
24:00, press the timer button, then the function is turned off, when the timer function is set,
the timer countdown starts in 5 seconds, and after the timer is over, it enters standby mode;
Timer (CH9000)
First click on the time and temperature keys two times, the temperature function is open, the
temperature began to flicker, Press "+" or "-" key to set the temperature (set temperature
must be greater than the current temperature)。Press the timer button, each time the time is
increased by 1 hour, when the timer time is 24:00, press the timer button, then the function
is turned off, when the timer function is set, the timer countdown starts in 5 seconds, and
after the timer is over, it enters standby mode;
Temperature
Press the temperature unit selection button to change the value. By default these are
Celsius degrees. Press the "+" or "-" button to set the temperature (the set temperature
14

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ch8000Ch9000

Tabla de contenido