Uline H-8649 Manual De Instrucciones página 3

EXHAUSTING HOT AIR
In cooling mode, the appliance must be placed close
to a window or opening so that the warm exhaust air
can be ducted outside.
First, position unit on a flat floor. Make sure there is a
minimum of 31.5" clearance in the front/back of the unit,
and a minimum of 19.7" clearance in the left/right sides
of the unit and that it is within the vicinity of a single
circuit outlet power source.
1. Extend either side of the hose. (See Figure 2)
Extend the side of hose
2. Screw the hose onto adapter A. (See Figure 3)
3. Extend the other side of the hose and screw it to
adapter B. (See Figure 4)
4. Slide the assembly onto unit. (See Figure 5)
Slide onto
PAGE 3 OF 30
INSTALLATION
Figure 2
Figure 3
Figure 4
Figure 5
5. Affix adapter B into the window slider kit and seal.
(See Figures 6 and 7)
Vertical
Window
Window Slider Kit
Minimum: 26.6"
Maximum: 52.5"
Horizontal
Window
Window Slider Kit
Minimum: 26.6"
Maximum: 52.5"
The hose can be extended from its original length of
15" up to 59", but it is the best to keep the length to the
minimum required. Also, make sure that the hose does
not have any sharp bends or sags. (See Figure 8)
Figure 6
Figure 7
Figure 8
0320 IH-8649