Swing Operation; Fault Code - Uline H-8649 Manual De Instrucciones

SWING OPERATION

When you turn on the unit, the louver will swing and stop
at a certain angle. You can press the SWING button
to let the louver swing automatically. Press the SWING
button again when you want the louver stopped at
desired angle.
CHECK FILTER FEATURE
This feature is a reminder to clean the air filter (see Care
and Cleaning) for more efficient operation. The "filter"
indicator will illuminate after 250 hours of operation.
To reset after cleaning the filter, press the FILTER RESET
button and the light will go off.

FAULT CODE

If the display reads "EA," the room
temperature sensor has failed. Contact
Uline Customer Service at 1-800-295-5510.
If the display reads "ES," the evaporator
temperature sensor has failed. Contact
Uline Customer Service at 1-800-295-5510.
If the display reads "E4," the display
panel communication has failed.
Contact Uline Customer Service at
1-800-295-5510.
If the display reads "P1," bottom tray is
full. Carefully move the unit to a drain
location, remove the bottom drain plug
and let the water drain away. Restart
the machine until the "P1" symbol
disappears. If error repeats, call Uline
Customer Service at 1-800-295-5510.
PAGE 8 OF 30
OPERATION CONTINUED
DRAINAGE
During the dehumidifying mode, you will need a
garden hose (sold separately) to drain the condensate
from the unit. Remove the rubber stopper from the hose
connector. (See Figure 21)
The hose may then:
a. Discharge into a drain that is lower than the unit.
b. Be connected to a condensate pump (sold
separately).
Garden Hose
Remove the
Supplied
Rubber
Stopper
Figure 21
0320 IH-8649