particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is en-couraged to try to correct the interference by one or more of the following
measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance
20cm between the radiator and your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.
Antenna:
The end-user product will be professionally installed in such a manner that only the
authorized antennas are used.
Caution:
Changes or modifications not expressively approved by SEW-Eurodrive void the user`s
authority to operate the equipment.
Operation is subject to the following two conditions:
This device has been designed to operate with an antenna having a maximum gain of
6.0dBi. Having a higher gain is strictly prohibited per regulations of Industry Canada.
The required antenna impedance is 50 ohms. To reduce potential radio interference to
other users, the antenna type and its gain should be so chosen that the equivalent
isotropically radiated power (EIRP) is not more than that required for successful
communication.
The installer of this radio equipment must ensure that the antenna is located or pointed
such that it does not emit RF field in excess of Health Canada limits for the Chapter 8:
Regulatory information 8.4:
Anexo a las instrucciones de funcionamiento – MOVIPRO
receiver is connected.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
SEW-EURODRIVE GmbH & Co KG
1 796 616 7 WLAN-Karte #MPCI-DCMA-82-MMCX
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This decive may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
Autorizaciones
USA / Kanada
FCC ID: VEB-NKRDCMA82
IC: 7177A-DCMA82
®
6
3320545291
15