Tripp-Lite P936-000 El Manual Del Propietario página 2

Installation
1. Connect the included Serial ATA (SATA) cable between the
SATA controller and the 7-pin SATA port on the P936-000.
2. Connect the included 4-pin power splitter cable to the mini
4-pin connector on the P936-000. Connect the other two 4-pin
connectors to the corresponding ports on the IDE hard disk and
the SATA controller.
Note: The IDE hard disk must be switched to master mode.
3. Connect the IDE connector on the P936-000 to the IDE hard disk.
200908081 93-2917.indb 2 9/9/2009 3:28:13 PM