Creative SoundBLASTER Jam Manual Del Usuario página 22

Troubleshooting
Sound Blaster JAM Controls and Indicators
Different actions can trigger the Sound Blaster JAM to go into different states. The table below lists the
controls and related actions, and the meaning of the LED indications.
Action
Power On/Off
Battery Charging
(when power off)
Battery Charging
(when power on)
Bluetooth Pairing
Incoming Phone Call
No sound from the headset.
Check the following:
The headset and your Bluetooth device are turned on.
l
The headset has sufficient battery power.
l
The volume settings in Sound Blaster JAM Control Panel and system audio are properly adjusted and
l
not muted.
There is no hardware conflict between the headset and a peripheral device.
l
The headset is selected as the default audio device. Ensure that existing analog headset is
l
disconnected.
There is clipping/distortion during audio playback.
Check the following:
LED
Green
(with power up tone)
Green
(with power down tone)
Red
Off
Red
LED returns to the last status
Blinks quickly in blue
(60 seconds)
Blinks slowly in blue
(Bluetooth connected tone)
Blinks slowly in green
(Bluetooth disconnected tone)
3 quick blue blinks every 2
seconds
(Ring tone)
2 quick blue blinks every 2
seconds
Blinks slowly in blue
Status
Power ON
Power OFF
Headset battery is charging
Battery charging is complete
Headset battery is charging
Battery charging is complete
Headset is searching for
Bluetooth-enabled devices
Headset is paired successfully
Headset is unpaired
Phone ringing
Answer call / active call
Reject call / end call
Troubleshooting 21