Playing An Audio Cd; Listening To Fm Radio - Oglo MS-O-300-D Manual De Instrucciones

playing an audio CD

Your micro hi-fi system can play audio CDs as well as MP3s recorded on CD-R or CD-RW.
Turn on the player using the button on the device or remote control. Select the DISC source by
1.
repeatedly pressing the button on the micro hi-fi system or by directly pressing the CD button
on the remote control.
Press to open the CD tray and then place a CD in it (printed side up).
2.
Close the tray. The device loads the CD, and displays information about its contents, such as total time
3.
and number of tracks, on the screen. Playback then starts automatically.
For CDs containing audio fi les in MP3 format, the micro hi-fi system starts playback with the fi rst
4.
track of the fi rst album in alphabetical order. To go directly to another track, briefl y press the
or button.
Basic Functions
Starts, pauses or resumes playback.
Stops playback.
Goes to the previous track. BASS
Press and hold to play backwards at high speed.
Goes to the next track.
Press and hold to play forwards at high speed.
INTRO Plays the fi rst 10 seconds of each track.
SHUFFLE Enables random playback of the CD.
ALBUM- /
When playing MP3s, goes to the next or previous folder.
ALBUM+
Repeat
When playing an audio CD, you can select a repeat option. Press REPEAT to repeat a track, a second
•
time to repeat the entire CD, and a third time to disable repeat. The repeat symbol is displayed in the
upper right corner of the screen.
When playing audio fi les in MP3 format, press REPEAT to repeat a track, a second time to repeat an
•
album, a third time to repeat the entire CD, and a fourth time to disable repeat.
Programming a playlist
When the micro hi-fi system is off, press the PROG button, and then select the desired track
•
number using the or
number.
36 36
button. Then press PROG again, and then select another track
Repeat as often as necessary (20 tracks maximum). Then press
•
order you have defi ned. Use the
Press the PROG button twice to cancel programming.
•

listening to FM radio

Connect the antenna cable provided to the back of the micro hi-fi system, and fully unfold it.
1.
Turn on the micro hi-fi system and select the FM source by repeatedly pressing the
2.
the micro hi-fi system or the remote control.
Performing a full scan of the FM band
When the unit is turned on, briefl y press the SCAN button on the remote control or the
1.
the micro hi-fi system to fully scan the FM band. The fi rst thirty stations found are stored.
Automatically searching for a radio station
TREBLE
Hold down the
1.
Scanning of the FM band stops when a radio station is found.
2.
You can then briefl y press the
3.
as described in the next section.
Manually searching for a radio station
Briefl y press the
1.
frequency.
Each time the
2.
MHz.
If reception is poor, adjust the FM antenna or change the frequency.
3.
Automatically storing radio stations
When the micro hi-fi system is turned on, select the FM station of your choice.
1.
Press and hold the PROG button. Memory number 01 fl ashes on the display. Use the
2.
button to select the desired memory number. Press
FM station. MEMORISED
Repeat as often as necessary.
3.
to start playback. Do this in the
or button to browse through your programming.
or button for 2 seconds to perform an automatic scan.
or button on the remote control to refi ne your search,
or button on the remote control until you obtain an optimal reception
or button is pressed, the frequency decreases/increases by 0.05
to confi rm the programming of the
appears on the display.
button on
button on
BASS
or
37