Maintenance And Cleaning; Troubleshooting Guide - Oglo MS-O-300-D Manual De Instrucciones

maintenance and cleaning

Cleaning the unit
Unplug the unit from the power point before cleaning.
1.
Only clean the unit with a soft, dry cloth.
2.
Do not use any liquid cleaners or aerosols.
3.
Notes on CDs
HANDLING CDS
Hold the CD by the edges and make sure that your fi ngers do not
touch the playback surface. Do not glue paper or put stickers on CDs.
CLEANING CDS
STORING CDS
Store CDs in their cases after use.
Do not expose CDs to very cold, damp or hot environments.
Never leave them in a parked vehicle exposed to sunlight.
DAMAGED CDS AND CDS IN OTHER SHAPES
Do not use cracked, chipped, deformed, or otherwise damaged CDs as
they may damage the player.
This player is designed to only be used with standard, 100% circular CDs.
Do not use CDs in any other shape.
Never lift or move the unit during playback: CDs rotate at high speed and
could be damaged.
46 46
Fingerprints and dust on a CD can cause poor sound quality
and distortion. Before playing, clean the CD with a clean, dry
cloth from the centre towards the edges.
Never use alcohol, benzene, thinner, cleaning fl uid or other
chemicals.
Do not use compressed air to clean dust.

troubleshooting guide

Before contacting your after sales service, perform the following basic checks. If you cannot solve the
problem by following the instructions below, contact your store.
SYMPTOMS POSSIBLE CAUSES
The unit's plug is not connected.
The micro hi-fi
system won't turn
on.
The mains socket is not powered.
The volume is set to the minimum or is
disabled.
No sound.
The wrong source is selected.
The micro hi-fi system is operating
Malfunction.
abnormally or emitting an unusual sound.
The remote control is too far away from
the micro hi-fi system.
There is an obstacle between the remote
The remote control
control and the unit.
is not working.
The battery is low.
The wrong source is selected.
The USB media
The audio format is incorrect.
does not play.
The removable device is not detected.
Your audio source is not in pairing mode.
The Bluetooth *
connection cannot
be established.
Make sure that the micro hi-fi system and your Bluetooth* device are within 8 meters
of each other and that no walls or electronic devices are interfering with transmission.
SOLUTIONS
Plug the unit into a mains socket.
Plug another device into the same mains
socket to perform a cross test.
Adjust the volume.
Briefl y press the button or the
VOL+ or VOL- buttons to reactivate the
volume.
Select the correct audio source by pressing
the
button several times.
Unplug the unit for 30 minutes. After 30
minutes, turn the micro hi-fi system back
on.
Bring the remote control closer to the
unit.
Remove any obstacles between the two
elements.
Replace the battery. Refer to the
"Remote Control - Inserting the
batteries" section on page 9.
the
Select the USB source by pressing
button several times.
BASS
Check that the audio formats are
compatible with this unit (MP3/WMA).
Unplug the removable device and plug
it back in.
Consult the user manual for your audio
source for more details.
47