BLACK&DECKER HG1500 Manual De Instrucciones página 17

4. Power tool use and care
The correct power tool will do the job better and safer at the rate for which it was designed.
a) Do not force the power tool. Use the correct power tool for your application.
b) Do not use the power tool if the switch does not turn it on and off. Any power
tool that cannot be controlled with the switch is dangerous and must be repaired.
before making any adjustments, changing accessories, or storing power tools. Such
c) Disconnect the plug from the power source and/or the battery pack from the power tool
preventive safety measures reduce the risk of starting the power tool accidentally.
with the power tool or these instructions to operate the power tool. Power tools are
d) Store idle power tools out of the reach of children and do not allow persons unfamiliar
dangerous in the hands of untrained users.
e) Maintain power tools. Check for misalignment or binding of moving parts, breakage of
have the power tool repaired before use. Many accidents are caused by poorly maintained
parts and any other condition that may affect the power tools operation. If damaged,
power tools.
f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting
edges are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc., in accordance with these instructions
working conditions and the work to be performed. Use of the power tool for operations
and in the manner intended for the particular type of power tool, taking into account the
different from those intended could result in a hazardous situation.
5. Service
replacement parts. This will ensure that the safety of the power tool is maintained.
a) Have your power tool serviced by a qualified repair person using only identical
b) If the replacement of the supply cord is necessary, this has to be done by the
manufacturer or his agent in order to avoid a safety hazard.
The tool is double insulated; therefore no earth wire is required. Always check that the
6. Electrical safety
main voltage corresponds to the voltage on the rating plate.
Warning! If the power cord is damaged, it must be replaced by the manufacturer, authorized
Black & Decker Service Center or an equally qualified person in order to avoid damage or
injury. If the power cord is replaced by an equally qualified person, but not authorized by
Black & Decker, the warranty will not be valid.
The label on your tool may include the following symbols:
7. Labels on tool
Read instructions manual
Use eye protection
Use ear protection
All manuals and user guides at all-guides.com
V ........... Volts
A ........... Amperes
Hz ......... Hertz
W........... Watts
min........ minutes
........ Alternating current
........ Direct current
17
ENGLISH
n .......... No-Load speed
0
........ Class II construction
........ Earthing terminal
........ Safety alert symbol
.../min.... Revolutions or reciprocation
per minute