Fellowes Powershred 74C Manual De Instrucciones página 4

Ocultar thumbs Ver también para Powershred 74C:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BASIC SHREDDING OPERATION
Insert waste bag (Fellowes #36052) for easy disposal.
Continuous operation:
10-12-minute maximum
NOTE: Shredder runs
briefly after each pass to
clear entry. Continuous
operation beyond
10-12-minutes will trigger
20-minute cool down
period.
TROUBLESHOOTING
A
B
Paper jam: Set to Off (O) and empty bin. Replace bin and follow the procedures below.
1
Press and hold
Reverse (R)
BASIC PRODUCT MAINTENANCE
OILING SHREDDER
performance. If not oiled, a machine may
experience diminished sheet capacity, intrusive
noise when shredding and could ultimately
recommend you oil your shredder each time
you empty your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
LIMITED PRODUCT WARRANTY
Limited Warranty: Fellowes, Inc. ("Fellowes") warrants the parts of the machine to be free of defects
in material and workmanship and provides service and support for 1 year from the date of purchase
by the original consumer. Fellowes warrants the cutting blades of the machine to be free from defects
in material and workmanship for 5 years from the date of purchase by the original consumer. If any
part is found to be defective during the warranty period, your sole and exclusive remedy will be repair
cases of abuse, mishandling, failure to comply with product usage standards, shredder operation using
an improper power supply (other than listed on the label), or unauthorized repair. Fellowes reserves the
Downloaded from
www.Manualslib.com
PAPER,
CARD or CD
1
2
Plug in and put
Set to Auto-On (I)
disconnect power
switch in ON (I) position
A. Safety lock: Make sure safety lock is in unlock position
B. Paper jam: Either press Reverse (R) and remove paper or follow Jam Buster instructions below
C. Overheat: Wait 20 minutes for motor to cool down
C
D
D. Door open: Make sure bin is pushed in
3
2
Gently pull uncut paper
If unable to remove paper, alternate
from paper entry.
slowly back and forth between
Auto-On (I) and Reverse (R)
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off (O)
manuals search engine
3
4
or
Feed into paper
cards, rotate safety flap
entry and release
in CD flap into place
4
5
3
2
Set to Reverse (R)
* Apply oil
2-3 seconds
across entry
right to charge the consumers for any additional costs incurred by Fellowes to provide parts or services
outside of the country where the shredder is initially sold by an authorized reseller. ANY IMPLIED
law. For more details or to obtain service under this warranty, please contact us or your dealer.
6
5
Hold card/CD at edge
Feed into center of
entry and release
6
Set to Off (O)
Gently pull uncut paper
from paper entry.
7
Set to Off (O)
3

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

4674001

Tabla de contenido