Installation Steps - LUND AVS Bugflector II Instrucciones De Instalación

Installation Steps

Attach fasteners to the (2) outboard hoodshield shield flanges by inserting screw with
washer through the hood shield, and into well nut. Partially thread screw into well nut.
3
Expose 2" (5 cm) of tape liner from each end of the center flanges on the hood shield. Ensure that free
4
Center part on front edge of hood and align holes.
5
With the fastener assembly inserted into hole in
hood, secure hood shield to hood by tightening
screw to expand well nut. Repeat for remaining
7
NOTE: DO NOT OVER TIGHTEN
NOTE: Actual application may vary slightly from illustrations.
ends are accessible.
fastener.
NOTE: Observe the alignment from the side view in
order to guide the hood shield with its attached fastener
into the proper hole in the hood.
Hood
Hood
shield
6
Note the (2) inboard hole locations.
8
Page 2 of 3
Screw
Washer
Hood shield
Well nut
free end
Well Nut
Screw and
Washer