Descargar Imprimir esta página

Publicidad

Enlaces rápidos

DESCRIPTION
The Model 10A microphone can be used in sound reinforcement or re-
cording, to pick up voices or instruments.
Features
Tailored frequency response provides intelligibility and crispness of
sound
Neodymium magnet for high signal-to-noise ratio
Cardioid (unidirectional) pickup pattern suppresses feedback
Locking On/Off switch
BASIC RULES FOR MICROPHONE USE
1.
Aim a directional microphone toward the desired sound source (for
instance, musical instrument, talker, singer) and away from undesired
sources (such as loudspeakers or another instrument) (Figure [1]).
2.
Locate the microphone as close as practical to the desired sound
source (Figure [2]) for best gain before feedback.
3.
Do not pick up the same sound source with more than one micro-
phone. Keep the distance between multiple microphones at least three
times the distance from each source to its intended microphone.
4.
Use the fewest microphones possible for the particular application.
5.
When extra bass response is desirable, work close to the microphone.
This phenomenon is known as "proximity effect".
6.
Locate microphones as far as possible from acoustically reflective
(hard, smooth) surfaces.
7.
Add an external windscreen when additional pop protection is needed:
outdoors in windy conditions or for closeup vocal use.
8.
To preserve directional characteristics, do not obstruct the microphone
grille.
SPECIFICATIONS
Type
Dynamic
Frequency Response
80 to 12,000 Hz (see Figure [3])
Pickup (Polar) Pattern
Cardioid (unidirectional) (see Figure [4])
2001, Shure Incorporated
27B3093 (AC)
TO REDUCE FEEDBACK,
AIM MIC WITH CARDIOID
POLAR PATTERN
(SHADED) AWAY FROM
LOUDSPEAKERS
[1]
KEEP THE MICROPHONE CLOSE
TO THE DESIRED SOURCE
[2]
Patent No. Des. 407, 407
MICROPHONE PICKUP
PATTERN (CARDIOID)
AMPLIFIER
Impedance (Z)
Low, rated 150 Ω (actual 180 Ω)
Output Level (at 1 kHz)
Open Circuit Voltage: –57.0 dBV/Pa* (0.14 mV)
Polarity
Positive pressure on diaphragm produces positive voltage on pin 2
with respect to pin 3.
Connector
Three-pin professional audio connector (male XLR)
Switch
Built-in locking On/Off switch. To lock switch On, loosen screw, push
lockplate forward, then tighten the screw.
Weight
240 g (8.5 oz.)
Certifications
Conforms to European Union directives, eligible to bear CE marking;
meets European Union EMC Immunity Requirements (EN 50082–1:
1992)
VARIATION
10AM
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
OPTIONAL ACCESSORIES
4.57 m (15 ft.) Cable (XLR-
6.1 m (20 ft.) Cable (XLR-
7.6 m (25 ft.) Cable (XLR-XLR)
Windscreen
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
REPLACEMENT PARTS
Cartridge
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Grille Assembly
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
For additional service or parts information, please contact Shure's
Service department at 1-800-516-2525. Outside the United States, please
contact your authorized Shure Service Center.
Model 10A User Guide
60 CM (2 FT)
TYPICAL FREQUENCY RESPONSE
[3]
o
180
o
150
o
120
500 Hz
1000 Hz
o
90
5000 Hz
–20 dB
–15 dB
o
60
–10 dB
–5 dB
o
30
0
PICKUP (POLAR) PATTERN
[4]
*1 Pa = 94 dB SPL
1
/
in.)
. . . . . . . . . . . . . . . . . . . . . . . . .
4
1
/
in.)
. . . . . . . . . . . . . . . . . . . . . . . . . .
4
. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
o
150
o
120
o
90
o
60
o
30
Swivel Adapter
C15HZ
C20HZ
C25J
A1WS
R187
RK339G
Printed in Mexico

Publicidad

loading

Resumen de contenidos para Shure 10A

  • Página 1 PICKUP (POLAR) PATTERN DESCRIPTION Impedance (Z) Low, rated 150 Ω (actual 180 Ω) The Model 10A microphone can be used in sound reinforcement or re- cording, to pick up voices or instruments. Output Level (at 1 kHz) Features Open Circuit Voltage: –57.0 dBV/Pa* (0.14 mV)
  • Página 2 Impédance (Z): Basse, nominale 150 Ω (180 Ω réelle) DESCRIPTION Le microphone modèle 10A peut être utilisé pour la sonorisation ou Niveau de sortie (à 1 kHz) l’enregistrement de voix ou d’instruments, à l’intérieur ou à l’extérieur. Tension de circuit ouvert : –57,0 dBV/Pa* (0,14 mV)
  • Página 3 Impedancia (Z) Baja, 150 Ω nominal (real 180 Ω ) El micrófono modelo 10A puede usarse en sistemas de refuerzo de sonido o grabaciones para la captación de voces o instrumentos, ya sea ba- Nivel de salida (a 1 kHz) jo techo o a la intemperie.
  • Página 4 A25D SHURE Incorporated Web Address: http://www.shure.com 222 Hartrey Avenue, Evanston, IL 60202–3696, U.S.A. Phone: 847-866–2200 Fax: 847-866-2279 In Europe, Phone: 49-7131-72140 Fax: 49-7131-721414 In Asia, Phone: 852-2893-4290 Fax: 852-2893-4055 Elsewhere, Phone: 847-866–2200 Fax: 847-866-2585...