Electrical Connection - Fabita linea Instrucciones

D
D:
_4th power level.
E
E:
_ON/OFF Key Light.
To switch on the hood, press A key, then it is possible to choose the
power level from 1 [min.] to 4 [max.]. If you were to opt for the first
power, you must re-choose key A, while if you decide on the other
alternatives you must choose the key corresponding to the desired
power, and therefore if you want the power at 2, you will need to
press key B, if key C is desired at 3, while if the maximum level is
desired, select 4, and then key D.
The Linea hood has an automatic timer, which allows you to
automatically go down to level 3 when you are at maximum power
(i.e. 4), after 7 minutes.
This function is also present for the other power levels, which is
activated by pressing the key of the desired power level for 3 sec.,
After which the automatic timer will make sure that after 15 min.
the Linea hood will automatically switch off.

ELECTRICAL CONNECTION

The mains voltage shall correspond to the one indicated on the
rating label found inside the hood. If provided with a plug , connect
the hood to a socket in compliance with current regulations and
positioned in an accessible area, even after installation.
If it not provided with a plug (direct mains connection) or if the
plug is in an inaccessible area, even after installation, use a double
pole switch in accordance with standards which ensures complete
disconnection from the mains under conditions relating to over-
current category III, in accordance with installation instructions.
Warning! Before -connecting the hood circuit to the power supply
and checking proper operation, always check that the mains lead is
correctly fitted.
Warning! The hood is provided with a special power cord; if the cord
is damaged, order a new one at our Technical Assistance Service.
16 16