Using The Appliance - Philips sonicare HX7990/02 Manual De Instrucciones

EnglisH
10

Using the appliance

Do not place the travel cap on the brush head
during sanitization.
1 After brushing, rinse the brush head and shake
off excess water.
 Place your finger in the door recess on the
right-hand side of the sanitizer and pull open
the door.
3 Put the brush heads into the sanitizer (see
chapter 'Preparing for use').
Note: Make sure the bristles of the brush head face the
light bulb.
4 Close the sanitizer door.
Note: The sanitizer does not work when the door is not
properly closed.
 Put the plug in a live power outlet.
6 Press the power on/off button to start the UV
clean cycle.
Note: The sanitizer is in operation when the blue light
glows through the window on the front of the sanitizer
and the UV clean LED flashes slowly.
Note: The sanitizer needs to run for the full 10-minute
UV clean cycle to get optimal results.
Note: When the sanitizing cycle is complete, the
UV clean LED turns solid green and the sanitizer
automatically shuts off.
Note: You can stop the sanitizer during the sanitizing
cycle by either pressing the on/off button or by opening
the door.