Declaration Of Conformity - Uline H-5803 Manual Del Usuario

RECYCLING
NOTE: Please recycle in line with local provisions
for the collection and disposal of electrical and
electronic waste under the WEEE Directive.
• DO NOT dispose of unit with household waste.
• ALWAYS dispose of batteries per local code.
CHANGE MEASUREMENT REFERENCE POINT
SINGLE MEASUREMENT
Press
Press to
for ON
Activate Laser
CONTINUOUS MEASUREMENT
Start Continuous Aim Laser
Measurement at Target
2 Seconds
PAGE 3 OF 15
SAFETY CONTINUED
Default measurement is from
the rear of the device.
2 second press to change
measurement reference from
back to front of device.
Measurement is from the
front of the device.
Aim Laser
Press for
At Target Measurement
Start Continuous/Capture
Measurement/Last Value

DECLARATION OF CONFORMITY

Stanley Tools declares that the CE Mark has
been applied to this product in accordance
with the CE Marking Directive 93/68/EEC.
This product conforms to IEC 60825-1:2014.
OPERATION
FUNCTION
ADDITION
Measure
SUBTRACTION
Measure
UNITS
Measure to Add
Press x 1
to Previous
to Activate
Measurement
"+"
Measure to Subtract
Press x 2
from Previous
to Activate
Measurement
"–"
2 Second Press to
Change Units (m/in/ft.)
0821 IH-5803