Declaration Of Conformity - Uline H-8816 Guia De Inicio Rapido

RECYCLING
NOTE: Please recycle in line with local provisions
for the collection and disposal of electrical and
electronic waste under the WEEE Directive.
• DO NOT dispose of unit with household waste.
• ALWAYS dispose of batteries per local code.
CHANGE MEASUREMENT REFERENCE POINT
SINGLE MEASUREMENT
Aim laser
Press
at target
for ON
CONTINUOUS MEASUREMENT
Start continuous Aim laser
measurement at target
2 Seconds
PAGE 3 OF 18
SAFETY CONTINUED
Default measurement is from
the rear of the device.
2 second press to change
measurement reference from
back to front of device
Measurement is from the
front of the device.
Press to
activate laser
Start continuous/capture
measurement/last value

DECLARATION OF CONFORMITY

DeWalt declares that the CE Mark has
®
been applied to this product in accordance
with the CE Marking Directive 93/68/EEC.
This product conforms to IEC 60825-1:2014.
OPERATION
FUNCTION
ADDITION
Measure
SUBTRACTION
Measure
UNITS
Measure to add
Press x 1
to previous
to activate
measurement
"+"
Press x 2 Measure to subtract
to previous
to activate
measurement
"+"
2 second press
to change units (m/in/ft.)
0720 IH-8816