HP Autozubehor HP20365 Manual Del Usuario página 19

VII. Operation
When processing wax and polishing agents, follow the manufacturer's instructions!
Fasten the foam disk to the polishing disk and pull the fine textile polishing bonnet over it. Make sure the
polishing bonnet is free of impurities.
Apply the polish evenly on the polishing disc. Do not apply the polish directly to the surface you wish to
polish.
Turn the polishing machine on/off only when the device is resting on the surface you wish to polish.
Lay the extension cable over your shoulder and process first the even, larger surfaces such as the engine
cover, deck lid and roof. Work with even movements.
Important! Allow the polishing machine to rest on the polishing surface, do not apply pressure!
Then move on to process the smaller surfaces (e.g. doors). Allow the power cable to dangle freely.
For difficult-to-reach areas, remove the bonnet from the disk and process the area by hand (e.g. rearview
mirror, bumpers, door handles, etc.).
Now replace the textile bonnet with the large polishing bonnet and pull it over the polishing disk. Make
sure it is free of impurities. Remove the polish coating in the same order it was applied.
Caution! Do not apply pressure to the polishing machine!
VIII. User manual
1. Installing the polishing bonnets
The electric tool is equipped with a fine and a coarse polishing bonnet. The fine bonnet is for applying the
polishing agent. The coarse bonnet is for polishing.
The bonnet should be fastened evenly and firmly to the foam disk.
There is a spindle lock on top of the device. Unlock the locking device only when the polishing machine is
standing still! Use the locking device to lock the spindle before simply turning the flange away from the
spindle to replace the polishing bonnet.
2. On/off switch and speed regulation
To start the polishing machine, press the safety button at the bottom of the handle and hold it for the
polishing process button. With the pressing button, You can use the control buttons (+ -) below the display
to show the speed
setting. The display shows the respective speed in the following
Steps: 06= 600 U, 10= 1000 U, 15= 1500 U, 20= 2000 U,
25= 2500 U, 30= 3000U.
3. Attaching the additional handle
Always firmly attach the additional handle to the machine before use.
Slide the additional handle fully into the attachment and refasten the screw.
8