B Elt Tension; R Epair; W Arranty; S Torage - SUHNER MACHINING MAX 100 Documentación Técnica

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 38
4.3 b
elt tensIon
The belt can be tensioned with the adjusting screw. Strike
the end briefly, and measure the natural frequency with a
frequency or belt tension meter.
Voltage for new belt:
To be determined according to the average conditions of
use.
4.4 r
epaIr
If despite strict observance of the manufacturing and test-
ing method the machine should happen to fail, it must be
repaired by an authorized SUHNER agency.
In all orders to the manufacturer please indicate the com-
ponent serial number of the machine (1).
4.5 w
arranty
In the event of the tool being improperly handled, used
for purposes for which it is not intended and/or of the ser-
vice and maintenance instructions not being observed by
non-authorized persons, no warranty shall be in effect for
damages/consequential damages. Complaints can only
be honored if the machine is returned in the undisassem-
bled condition.
4.6 s
torage
Temperature range: 20°C to +50°C
Max. relative air humidity: 90% at +30°C, 65% at +50°C
4.7 d
/ e
Isposal
nvIronmental compatIbIlIty
This machine consists of materials which can be dis-
posed of in a recycling process.
Before disposal, render the machine unusable.
Do not throw the machine into the garbage collec-
tion.
According to national regulations this machine
must be recycled in an environmentally-friendly manner.
30

Publicidad

Tabla de contenido
loading

Tabla de contenido