Installation Steps; Care And Cleaning - AVS Windflector Instrucciones De Instalación

Installation Steps

Center part on roof, and mark edges for
reference with masking tape.
3
Position roof wind deflector on roof and align with
previously marked locations. Press lightly on ex-
posed areas of tape and verify positioning.
5
Apply pressure along flange edges to ensure proper
7

Care and Cleaning

• Wash only with mild soap & dry with a clean cloth.
Congratulations!
You have purchased one of the many quality Auto Ventshade™ branded products offered by Lund International, Inc. We take the utmost pride in our
products and want you to enjoy years of satisfaction from your investment. We have made every effort to ensure that your product is top quality in
terms of fit, durability, finish and ease of installation.
Auto Ventshade
™
NOTE: Actual application may vary slightly from illustrations.
equal distant
from front
windhsield
and side to
adhesion.
Lund International, Ventshade Accessories Division
655 Raco Drive, Lawrenceville, GA 30045
800-241-7219 • Fax 770-339-5839 • Visit us at lundinternational.com
© 2005 Lund International, Inc. All rights reserved.
, the Auto Ventshade logo and the AVS
TM TM
Peel back 2" (5 cm) of tape liner from each end of
free end
side
4
With the roof wind deflector in its final position,
remove masking tape, and remove remaining tape
liner by pulling on free ends.
6
logo are trademarks of Lund International, Inc.
TM
Page 2 of 2
flange.
free end