Technical Parameters; Environment Protection - GRAPHITE 58G867 Instrucciones De Uso

●
Remove used grease with cloth.
●
Fill with new grease (approximately 30 g).
●
Install lid ( 9).
Do not apply more grease than approx. 30 g. Otherwise the power tool will not work properly. After
the supplied grease ends, use another available grease resistant to high temperature.
REPLACEMENT OF CARBON BRUSHES
Replace immediately worn out (shorter than 5 mm), burnt or cracked motor carbon brushes. Always
replace both brushes at a time.
●
Unscrew screws that fix the brush covers (
●
Unscrew brush caps.
●
Remove used brushes.
●
Remove any carbon dust with compressed air.
●
Insert new carbon brushes. Brushes should easily move into brush-holders.
●
Install brush caps.
●
Install brush covers ( 8).
After the brushes are replaced, start the demolition hammer with no load and wait until the brushes
fit to the motor commutator.
Entrust replacement of carbon brushes only to a qualified person. Only original parts should be
used.
All faults should be repaired by service workshop authorized by the manufacturer.
RATED PARAMETERS
Parameter
Supply voltage
Current frequency
Rated power
Protection class
Impact rate
Impact energy
Drill shank
Weight, w/o accessories
Year of production
NOISE LEVEL AND VIBRATION PARAMETERS
Sound pressure Lp = 83 dB(A) K=3 dB(A)
A
Sound power Lw = 107 dB(A) K=3 dB(A)
A
Weighted value of vibration acceleration a
Do not dispose of electrically powered products with household wastes, they should be utilized
in proper plants. Obtain information on wastes utilization from your seller or local authorities.
Used up electric and electronic equipment contains substances active in natural environment.
Unrecycled equipment constitutes a potential risk for environment and human health.
* Right to introduce changes is reserved.
"Grupa Topex Spółka z ograniczoną odpowiedzialnością" Spółka komandytowa with seat in Warsaw at ul. Pograniczna 2/4 (hereinafter Grupa
Topex) informs, that all copyrights to this instruction (hereinafter Instruction), including, but not limited to, text, photographies, schemes,
drawings and layout of the instruction, belong to Grupa Topex exclusively and are protected by laws accordingly to Copyright and Related
Rights Act of 4 February 2004 (ustawa o prawie autorskim i prawach pokrewnych, Dz. U. 2006 No 90 item 631 with later ammendments).
Copying, processing, publishing, modifications for commercial purposes of the entire Instruction or its parts without written permission of
Grupa Topex are strictly forbidden and may cause civil and legal liability.
8) (fig. D).

TECHNICAL PARAMETERS

Demolition Hammer
= 13.68 m/s 2 K=1,5 m/s
h

ENVIRONMENT PROTECTION

13
Value
230 V AC
50 Hz
1700 W
II
-1
1300 min
45 J
Hexagonal (30 mm)
17 kg
2014
2