Remote Controller Operation - Pelonis FZ10-19JR Manual De Instrucciones

Normal mode：the fan runs constantly at the speed which
have been selected.
Natural mode：the fan randomly cycles through speed settings
like a nature breeze.
Sleep mode：If setting on H speed：the fan runs at H speed for
(30±1 minutes）--Middle speed （30±1 minutes）-- finally at low speed;
If setting on M speed：runs at Middle speed （30±1 minutes）-- finally at
low speed;
If setting on L speed: runs at low speed.
4. " " OSC/LOUVER KEY
After the fan has started, press this key to select oscillation mode. The lights on the
display can indicate fan oscillation mode.
5. " " TIMER KEY
Press this timer key repeatedly to set the time for air delivery. Increase in
increments up to "1-2-3-4-5-6-7" hours.
b. REMOTE CONTROL
Battery Installation (included)
1. Push the button next to the battery cover to release the battery cover.
2. Insert 1 x CR2032 type lithium battery (included), making sure "+" side is facing up
as shown in the diagram(Fig 5).
3. Once battery is installed, push battery cover closed.
Remote Control Battery Cover
c. REMOTE CONTROLLER OPERATION
Point the remote controller at the receptor on body of the fan and press the desired
button. The remote controller will work at distances of up to roughly five meters and
the angle of 30 degree included between right and left from the receptor.
The batteries must be removed from the remote controller before it is scrapped and
that they are disposed of safely.
PULL
PUSH
Fig.5
3
Battery