Maintenance And Environmental Protection - MeisterCraft MMS 800 E Manual Del Usuario

5454210-Multi-Elek-man_a 02.12.11 09:49 Seite 62
three minutes to allow the machine to
cool down.
CAUTION! When sawing metal,
and steel in particular, regularly
cooling breaks should be taken in
order to allow the saw blade to cool,
or brush the blade with a cutting oil!
This will considerably increase the
durability and edge retention of the
blade.
Sawing without pilot hole (Figure 5)
If you need to make a cut in a work
piece and it is not possible to make a
test hole, set the pendulum action to 0,
release the saw shoe, push it right back
and lock into place. With the saw blade
in a tipped machine position and the
machine running, careful guide it across
the work piece (a). As soon as the work
piece has been sawn through, continue
working with the machine in the normal
position (b).
CAUTION! Such usage is only
possible with short blades and
soft materials, such as soft wood or
insulation materials.
Sawing flush (Figure 6)
When used in conjunction with elastic
bi-metal blades (not included) you can,
for example, cut projecting elements
(water pipes etc.) directly flush with the
wall. Place the saw blade up directly
against the wall and use lateral pressure
on the machine to bend it until the saw
shoe (3) lies against the wall. Switch the
machine on and apply constant, lateral
pressure while sawing off the work
piece.
Application examples
62
Figure 7: Sawing plastic/metal
Figure 8: Aerated concrete
Figure 9: Shortening plastic pipes
Figure 10: Cutting wood
10 – Maintenance and
environmental
protection
CAUTION! Unplug from the
power source!
Never submerge electrical machinery in
water. Additional notes can be found in
the operating instructions.
Wipe the housing with a damp cloth and
dry well. Do not use any cleaning
products. Remove the dust from the
ventilation slots and the blade holder,
and if necessary use a vacuum cleaner.
CAUTION! Electrical and battery
operated units that no longer work
should not be disposed of in the
household waste! They are to be
collected separately, in accordance with
the 2002/96 EC directive for
the disposal of electrical and
electronic waste, and sent
for proper and
environmentally-friendly
recycling.
Please discard power tools no longer
usable at a local collection point.
Collection and disposal of packaging
materials separately by types
complying with local rules and
regulations. For details, please
contact your municipal authority
concerned.