Requirements For The Installation Location - Denios SpillGuard Guia De Inicio Rapido

WARNING
• If the housing is opened there is a risk of
an explosion in Ex atmospheres.
• This can cause severe injuries or death.
• Opening the housing is prohibited.
Opening of the SpillGuard® housing is not
W
permitted.
The battery must not be changed.
W
A list of substances which are not suitable
W
to be used with SpillGuard® can be found
here:
www.denios.com/spillguard
These substances are prohibited for use
without exception.
2.4. Obligation to inspect spill sumps
The operator of containment devices is
obliged to carry out and document the
inspections required by Stawa R and the
General Technical Approval.
The use of the SpillGuard® is independent
of this.
2.5. Limited duration of use
SpillGuard® cannot be used once it has
W
detected a leak and must be replaced.
Due to its construction SpillGuard® must
W
be replaced after 5 years, to guarantee
successful leak detection.
i
INFORMATION
The SpillGuard® battery must not be replaced!
3. Requirements for the
installation location
SpillGuard® is is mainly to be used in the
bottom of a spill sump.
The following prerequisites must be met:
The base of the spill sump must be free of
W
any type of contamination.
The base must be level.
W
There must be suffi cient space available
W
for SpillGuard®.
The installation location should be at the
W
lowest point of the spill sump so that a
leak is detected as early as possible.
SpillGuard® Quick Guide | 269803 | Rev. 0
15/40