Care And Cleaning - Hamilton Beach 40614 Manual De Instrucciones

Care and Cleaning

1
Unplug and allow to cool before
cleaning.
4
Rinse well.
840223301 ENv02.indd 7 840223301 ENv02.indd 7
2
WARNING! Electrocution and
Shock Hazard: Do not immerse
percolator, cord, or plug in any
liquid.
Coffee Basket Lid
Coffee
Basket
Stem Assembly
5
WARNING! Electrocution and
Shock Hazard: Do not immerse
percolator, cord, or plug in any
liquid.
3
TO REMOVE MINERAL DEPOSITS AND BUILDUP:
Clean percolator after every 15 to 20 cycles to remove mineral
deposits and buildup, or more frequently in areas with hard water.
1. Fill the percolator with equal parts cold water and vinegar: six cups
each of cold water and white vinegar. Do not fill beyond 12-cup line.
2. Assemble percolator with stem assembly, coffee basket, coffee
basket lid, and twist-off lid.
3. Plug in and let unit go through the perk cycle. When perking has
stopped, let sit another 15 minutes.
4. Unplug and drain the percolator. Let cool; then clean by following
steps above in "Cleaning and Care."
NOTICE: To avoid damage to the
percolator, do not use abrasive
cleansers or pads, since these
may scratch the finish. See
exception for cleaning heating
well below.
To Clean Heating Well: Fill the
percolator half-full with hot water.
Add a drop of liquid dishwashing
detergent and wash the inside
of the percolator. Use a scouring
pad and clean the inside of
the heating unit well. This part
must be properly cleaned to
maintain the proper operation of
the percolator. Do not immerse
percolator in water.
7/2/13 8:23 AM 7/2/13 8:23 AM
7