H&O Equipments CryoPen Manual Del Usuario página 10

Step 2 Puncture the unused cartridge
Gently screw the CryoPen's backend onto the frontend.
Go to the point where you feel that the contact between
the assembled filter/opener and the cartridge is established.
Now, position your hands so that the last turn will be in an
uninterrupted movement. Now, rotate quickly until you feel
that the end of the rotation is achieved.
You may eventually hear a short hissing sound.
The shorter the hiss, the better!
Discharge the used cartridge & empty the cavity
Before loading a new cartridge, first release any unused
gas from the current cartridge by unscrewing the applicator
followed by pressing the trigger. Then unscrew the backend.
Discard the used cartridge and filter/opener. Regarding
CryoPen X+, CryoPen O, CryoPen XP be careful not to throw
the converter 16/8g. Ensure that the used filter/opener does
not remain inside the cavity. You should have the cavity empty
of any remaining parts.
Empty loading cavity
10
Step 3
Remove the applicator cap. Gently squeeze the trigger
to start the flow of N
flow of cryogenic liquid. 1 or 2 seconds after releasing the
trigger, the remaining gas in the applicator is discarded.
A cartridge can be used for several treatments and patients.
Let's see how to load
our youtube channel -
Blistered cartridge and
assembled filter/opener *
Use your CryoPen
O. Release the trigger to close off the
2
your device? Adapter to convert the backend
- let's see
Converter 16/8g:
for a 8g cartridge