Tabla de contenido
Publicidad
3.3 - Gender
3.5 - Optimal value
3.7 - Body fat %
3.9 - Body hydration %
3.11 - Body muscle %
3.13 - Body bone
BEFORE FIRST USE
Insert the correct batteries into the compartment (See "Replacing the battery")
WEIGHING
1) Place the scales on a hard and flat surface (avoid carpets and soft surfaces).
2) Gently step on the scales. Stand on the scales evenly distributing your weight and do not move until your weight reading shown on the
display stops changing and gets blocked.
SETTING MEASUREMENT PARAMETERS
1) Place the scales on a hard and flat surface
2) Press the (c) button. An option to set the user code will appear.
3) Use the (a) and (b) buttons to choose a user code.
4) Press (c) to confirm.
Repeat steps 3 to 4 to set the gender, height and age. After approximately a few seconds from the last press of the SET button the scales
will switch to the weighing and measuring mode.
WEIGHING WITH MEASUREMENT
1) Press the (c) button. The last user's parameters will appear. If you want to change the user or parameters use the (a) and (b) buttons.
Wait until the display shows "0".
2) Gently step on the scales with bare feet. Both feet should touch the measurement plates (1.4). Stand on the scales evenly distributing
your weight and do not move until your weight reading shown on the display stops changing and the measurement sign: 0000 appears.
Next a sequence of fat, water, muscle, bone and calorie measurements results will appear. They will be repeated three times and saved to
the scales memory.
MEASUREMENT CONTROL
The results of the previous measurement can be retrieved using the (c) button after turning the scales on. Next, select the user code and
wait several seconds until the scales display "0". Using the (a) and (b) buttons switch between the results.
SELECTING UNITS OF MEASURE (Fig. 2):
Press the UNIT button to change the units of measure. The unit will be visible on the display.
MESSAGES
C - Error
Lo – Low battery
Err – Excessive scale load
0000 - During measurement
REPLACING THE BATTERY
Remove the lid of the battery compartment at the bottom of the scale. Remove the old battery. Insert the new battery of the right type.
Close the lid of the battery compartment.
CLEANING AND MAINTENANCE
– Gently wipe the scale with a dry or slightly damp cloth.
TECHNICAL DATA
Power: 1 x 3V CR2032
Capacity: 150kg (330 lb)
Accuracy: 100g
To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste
bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may
effect the environment. Do not dispose this appliance in the common waste bin.
LESEN SIE AUFMERKSAM WICHTIGE ANWEISUNGEN BEZÜGLICH DER SICHERHEIT
DER BENUTZUNG UND BEWAHREN SIE DIESE FÜR DIE ZUKUNFT AUF
1. Bevor mit der Benutzung begonnen wird, ist die Betriebsanweisung aufmerksam zu
lesen. Weiterhin ist in Übereinstimmung mit den in dieser Betriebsanweisung enthaltenen
Hinweisen zu handeln. Der Produzent trägt keine Verantwortung für Schäden, die durch die
nicht bestimmungsgemäße Benutzung des Geräts oder aufgrund seiner unsachgemäßen
Bedienung verursacht wurden.
2. Das Gerät darf ausschließlich für den Haushaltsbedarf benutzt werden. Verwenden Sie
dieses Gerät nicht für andere Zwecke, die seiner Bestimmung nicht entsprechen.
3. Während der Benutzung des Geräts ist besondere Vorsicht zu wahren, vor allem dann,
3.4 - Weight unit
3.6 - Calorie intake recommendation
3.8 - Height unit
3.10 - Age
3.12 - Percentage proportion
3.14 - Body mass index
DEUTSCH
5
Publicidad
Tabla de contenido
