Power Saving (Sleep) Mode - Directed 3121 Guia Del Usuario

Power Saving (Sleep) Mode

• After 24 hours in the armed status, the LED will flash at a
slower rate at once every 4 seconds, and after 48 hours, it
will flash once every 8 seconds.
• After 96 hours of no activity (arm or alarm trigger) the alarm
enters sleep mode. The alarm receiver and LED turn off to
save as much battery power as possible. The system is draw-
ing next to no current in this mode. Cycling the ignition will
wake the unit up.
• If any other input is activated when in sleep mode, the system
will wake up, and the siren will chirp 10 times.
Note: This system is equipped with a sleep mode to lower cur-
rent draw. After 96 hours of no activity, the system's sleep mode
turns on and RF communication shuts down. If your system is not
responding to remotes, you may need to cycle ignition to wake
the unit up before remotes will control the system again.
© 2018 Directed. All rights reserved.
11