Eagle Group Flex-Master 311944 Instrucciones Para El Ensamblaje

Flex-Master
PART #311944
#1
#2
#4
#3
4-Post Kit
# qty part number
#1 . .4 . . .varies . . . . . . . . . . . . . . . . .Post (18˝, 30˝ or 48˝)
#2 . .2 . . .311915 . . . . . . . . . . . . . . . .mounting plate
#3 . .4 . . .300962 . . . . . . . . . . . . . . . .
#4 . .4 . . .300964 . . . . . . . . . . . . . . . .lock washers
#5 . .1* . .PLASTIC SPLIT SLEEVES . .plastic split sleeves
*one pack per shelf ordered
(Note: Before assembly, NSF-approved silicone will be needed.)
Mounting Plates
1
Place a bead of RTV silicone around the bottom of the mounting plates. The bead should be 1/8˝ from
the outer edge of the plate and provide a complete seal. Place plates on tabletop. Assemble bolts up
from the bottom side of the tabletop, through the plates, and into the bottom of the posts.
Hand-tighten. Wipe away excess silicone sealant. Refer to figure 1.
First Shelf
2
Referencing numbers on posts, snap plastic tapered split sleeves onto each post at desired location
for the lowest shelf. Refer to figure 2. The thicker part of the taper goes towards the bottom. Make
sure the rib on the split sleeve is seated into the groove at the selected height. Lower the first shelf
over the posts until the split sleeves are seated snugly within the collars.
3
Additional Shelves
Snap split sleeves onto posts at the desired location for the second shelf. Lower shelf onto posts
until split sleeves are snugly seated with corner collars. Repeat for additional shelves. Securely seat
all shelves by placing a board across the corners of the shelves and gently tapping with a hammer.
Shelf is now ready for use.
Eagle Foodservice Equipment, Eagle MHC, SpecFAB, and Retail Display are divisions of Eagle Group. ©2007 by the Eagle Group
ASSEMBLY INSTRUCTIONS
figure 1
(table base)
Parts Lists
description
1 ⁄ ˝ x 13˝ x 1 1 ⁄ ˝ bolts
2 2
• 100 Industrial Boulevard, Clayton, Delaware 19938-8903 U.S.A. • www.eaglegrp.com
• Phone: 302/653-3000 • (Foodservice) 800/441-8440 • (MHC/Retail) 800/637-5100
• Fax: 302/653-2065
Overshelf for Tables
®
#5
# qty part number
#1 . .6 . . .varies . . . . . . . . . . . . . . . . .Post (18˝, 30˝ or 48˝)
#2 . .3 . . .311915 . . . . . . . . . . . . . . . .mounting plate
#3 . .6 . . .300962 . . . . . . . . . . . . . . . .
#4 . .6 . . .300964 . . . . . . . . . . . . . . . .lock washers
#5 . .1* . .PLASTIC SPLIT SLEEVES . .plastic split sleeves
*one pack per shelf ordered
figure 2
(overshelf)
6-Post Kit
description
1 ⁄ ˝ x 13˝ x 1 1 ⁄
2 2
EG9836
˝ bolts
(End)
Revised 02/07