Operation - Wilfa FROSTBITT ICE-12S Manual De Instrucciones

OPERATION

EN
1. Open the cover, remove the basket and pour water into the container.
2. Ensure that the water level is kept below the maximum water level.
3. Press the "ON/OFF" button on the control panel to turn the appliance on.
4. Select ice cube size by pressing the "SELECT" button. If the room
temperature is lower than 15 °C, we recommend selecting small ice cubes in
order to prevent the ice from sticking together.
5. The ice cube cycle is between 6 and 13 minutes, depending on ice cube size
and room temperature. The recommended room temperature is 10 °C to
43 °C.
6. If the "Add Water" indicator is lit up, water must be refilled before the ice
cube cycle starts again. Press the "ON/OFF" button, fill water up to the
maximum water level and press the "ON/OFF" button again to turn the unit
back on. Allow the appliance to rest for at least 3 minutes before starting it
again.
7. If the "Ice Full" indicator is lit up, the unit will stop and the ice cubes must
be removed from the basket.
8. For reasons of hygiene, the water in the container should be changed at
least once a day.
Warning: Direct sunlight or glare from sunlight could result in infrared sensor
failure. The sensors in the appliance will then not function optimally. Keep the
unit away from sunlight.
INSTRUCTION MANUAL · FROSTBITT
10