Care & Cleaning; Troubleshooting - HAMPTON BAY 29504 Guía De Uso Y Mantenimiento

Assembly and Installation (continued)
2
Connecting the wires
□
Connect the female end (AA) of the transformer (F) to the male end (BB) of the wire connector (G).
□
Connect the first fixture's male connector (DD, the short one) to the plug connector (CC) of the wire connector (G).
□
Connect the second fixture's male connector (DD, the short one) to the first female connector (EE, the long one).
□
Connect the third fixture's male connector (DD, the short one) to the second female connector (EE, the long one).
□
Hand-tighten the threaded connector covers to prevent water intrusion.
NOTE: If the photocell on the transformer is
too close to the fixture, the flower light will not
turn on.
Operating your remote control
Remote control - Your LED flower light is equipped with a remote control (H) to select the color of light.
□
Point the remote control (H) toward the fixture while using.
□
Press buttons one, two or three once to choose a single color. Continue to a press button to cycle through all seven colors.
□
Press the AUTO button once to automatically cycle through all seven colors.
NOTE: The remote distance range between the
transmitter and receiver is 16 feet.
Care & Cleaning
□
Clean the flower lights with a damp cloth. Do not use any chemicals or abrasives.

Troubleshooting

Problem Possible Cause
□
Lights do not turn on.
□
□
□
Lights do not change color.
□
□
Lights do not turn off during
daylight.
□
Lights flicker (all fixtures).
Warranty
The manufacturer warrants this product to be free for two (2) years against any defects that are due to faulty materials or workmanship. This warranty applies only
to the original consumer and only to products used in normal use and service. If this product is found to be defective, the manufacturer's only obligation, and your
exclusive remedy, is the repair or replacement of the product at the manufacturer's discretion, provided that the product has not been damaged through misuse,
abuse, accident, modifications, alterations, neglect or mishandling. This warranty shall not apply to any product that is found to have been improperly installed, set
up, or used in any way not in accordance with the instructions supplied with the product. This warranty shall not apply to a failure of the product as a result of an
accident, misuse, abuse, negligence, alteration, or faulty installation or any other failure not relating to faulty workmanship. This warranty shall not apply to the finish
on any portion of the product, such as surface and/or weathering, as this is considered normal wear and tear. The manufacturer does not warrant and specifically
disclaims any warranty, whether expressed or implied, or fitness for a particular purpose, other than the warranty contained herein. The manufacturer specifically
disclaims any liability and shall not be liable for any consequential or incidental loss or damage, including any labor/expense costs involved in the replacement or
repair of said product.
Contact the Customer Service Team at 1-877-527-0313 or visit www.HamptonBay.com.
□
No power
□
Disconnected/break in the
wire
□
The photocell is install
close to the light source
□
Remote control is out of
□
power
Remote control is out of
range
□
Photocell is incorrectly
placed
□
Loose connection at the
transformer
DD EE
Check the outlet and ensure that a breaker or GFI circuit has not been tripped.
Follow the wires from the fixture and ensure a continuous connected path back to the
transformer.
Remove the photocell away from the fixtures or other light source.
Make sure the battery is in the remote.
Ensure you are using the remote control in the normal range of 16 feet.
Reposition photocell in area with adequate light (away from shrubs or trees).
Unplug the transformer from the outlet and visually inspect the positive and negative con-
necting posts. Each wire should be securely screwed in and not in contact with any other.
2
DD EE DD CC
G
Solution
BB AA
F