Care And Cleaning; Troubleshooting; Cable Selection - HAMPTON BAY JAO1501L-2 Guía De Uso Y Cuidado

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Care and Cleaning

□

Clean the fixture with a soft dry cloth.

Troubleshooting

Problem

Possible Cause

The fixture will not

□

There is no power.

light.

□

There is a disconnection or

break in the wire.

□

The transformer setting is

incorrect.

The light flickers

□

There is a loose wire

(one fixture).

connector to the fixture.

The lights flicker

□

There is a loose connection at

(all fixtures).

the transformer.

Warranty

WHAT IS COVERED

The manufacturer warrants this lighting fixture to be free from defects in materials and workmanship for a period of five (5) years from date of purchase. This warranty

applies only to the original consumer and only to products used in normal use and service. If this product is found to be defective, the manufacturer's only obligation,

and your exclusive remedy, is the repair or replacement of the product at the manufacturer's discretion, provided that the product has not been damaged through

misuse, abuse, accident, modifications, alterations, neglect or mishandling.

WHAT IS NOT COVERED

This warranty shall not apply to any product that is found to have been improperly installed, set-up, or used in any way not in accordance with the instructions supplied

with the product. This warranty shall not apply to a failure of the product as a result of an accident, misuse, abuse, negligence, alteration, or faulty installation, or any

other failure not relating to faulty material or workmanship. This warranty shall not apply to the finish on any portion of the product, such as surface and/or weathering,

as this is considered normal wear and tear.

The manufacturer does not warrant and specifically disclaims any warranty, whether express or implied, of fitness for a particular purpose, other than the warranty

contained herein. The manufacturer specifically disclaims any liability and shall not be liable for any consequential or incidental loss or damage, including but not

limited to any labor / expense costs involved in the replacement or repair of said product.

Contact the Customer Service Team at 1-855-HD-HAMPTON or visit HAMPTONBAY.COM.

Cable Selection

12 VOLT TAP

Total Fixture Wattage

0-60 Watts

61-120 Watts

121-180 Watts

181-240 Watts

241-300 Watts

600W Transformer = (2x300) Watts

900W Transformer = (3x300) Watts

15 VOLT TAP

Total Fixture Wattage

0-60 Watts

61-120 Watts

121-180 Watts

181-240 Watts

241-300 Watts

600W Transformer = (2x300) Watts

900W Transformer = (3x300) Watts

* NOT RECOMMENDED FOR HALOGEN LANDSCAPE LIGHTS

This data is provided as a general guideline. Actual performance will depend on the installation layout, the fixtures, and the condition of the cable.

NOTE: Most LED landscape lighting fixtures can operate with full illumination from 9V down to as little as 6V. It is possible to have extended length runs

with LED fixtures that go beyond the specifications shown in the guidelines above.

□

Do not use any cleaners with chemicals, solvents or harsh abrasives.

Solution

□ Check the outlet and ensure that a breaker or GFCI circuit has not been tripped.

□ Follow the wires from the fixture and ensure a continuous connected path back to the transformer.

□ Check the settings on the transformer.

□ Tighten the wire connector and ensure the metal contacts pierce the insulation on the low voltage

cable from the transformer.

□ Unplug the transformer from the outlet and visually inspect the positive and negative connecting

points. Each wire should be securely screwed in and not in contact with any other.

0-50 feet