Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DWS-130SP-ENG.qxd
10/12/04
11:36 AM
Where can I mount the remote sensor?
To get accurate readings and to prolong the life of your sensor, we rec-
ommend that you mount it out of direct sunlight and rain. Fog and mist will
not affect the sensor, but large volumes of soaking rain may. To guard
against this, we recommend that you mount it under the eve of your house,
your garage or any other suitable place that will keep it out of direct sun
and rain.
Outdoor Temperature Reading shows " - - "
This is usually an indication that the channel selector (located in the top left
corner of the home receiver) is set incorrectly to receive the signal from the
remote sensor. If you have only one remote sensor, ensure that the
channel selector is set to "1". To change the channel, press the "channel"
button located on the front of the home receiver.
The home receiver may also be "scrolling" - looking for sensor readings
from more than one remote sensor. This home receiver can support up to
three remote sensors (only one is included). If it is looking for more than
one remote sensor, a "
Again, to select a reading from just one remote sensor, press the "channel"
button to remove the scroll icon and ensure that the channel selected now
reads "1".
Page 9
" icon will appear below the channel designator.
8
SPECIFICATIONS
Range of temperature measurement:
Indoor temp :
+32 F to +122 F (0 C to + 50 C)
Remote sensor:
-4 F to +140 F (-20 C to +60 C)
Channel:
max. 3 remote sensors
Temp. Alert:
Indoor Temp/Ch 1
Transmission:
max. 100 ft. (30 m) open area, RF434 MHz
Resolution:
0.1 degree for temperature
Power source:
2 Alkaline AA batteries - home receiver
2 Alkaline AA batteries - remote sensor
9
Publicidad
Tabla de contenido
