Makita LS1013 Manual De Instrucciones página 12

Sub-fence
1
001545
This tool is equipped with the sub-fence which should
ordinarily be positioned as shown in the figure.
However, when performing left bevel cuts, set it to the
left position as shown in the figure.
CAUTION:
When performing left bevel cuts, flip the fence over
•
to the left position as shown in the figure.
Otherwise, it will contact the blade or a part of the
tool, causing possible serious injury to the
operator.
1
001546
Sub-fence R (optional accessory)
001547
The sub-fence R can be installed on the right side of the
guide fence. Insert the rods of the sub-fence R into the
holes in the guide fence. Tighten the screws which come
with the sub-fence R to secure the sub-fence R.
CAUTION:
When performing right bevel cuts, never use the
•
sub-fence R. It will contact the blade or a part of
the tool, causing possible serious injury to the
operator.
1. Sub-fence
1. Sub-fence
1. Sub-fence R
1
2. Screws
2
Vertical vise
2 1
3
001548
The vertical vise can be installed in two positions on
either the left or right side of the guide fence or the base.
Insert the vise rod into the hole in the guide fence or the
base and tighten the screw on the back of the guide
fence to secure the vise rod.
Position the vise arm according to the thickness and
shape of the workpiece and secure the vise arm by
tightening the screw. If the screw to secure the vise arm
contacts the guide fence, install the screw on the
opposite side of vise arm. Make sure that no part of the
tool contacts the vise when lowering the handle fully and
pulling or pushing the carriage all the way. If some part
contacts the vise, re-position the vise.
Press the workpiece flat against the guide fence and the
turn base. Position the workpiece at the desired cutting
position and secure it firmly by tightening the vise knob.
CAUTION:
The workpiece must be secured firmly against the
•
turn base and guide fence with the vise during all
operations.
Horizontal vise (optional accessory)
1
2
001550
The horizontal vise can be installed in two positions on
either the left or right side of the base. When performing
15° or greater miter cuts, install the horizontal vise on
the side opposite the direction in which the turn base is
to be turned.
12
1. Vise arm
4
2. Vise rod
3. Screw
4. Vise knob
5. Guide fence
5
1. Vise plate
2. Vise nut
3. Vise knob
3