Publicidad
Idiomas disponibles
Idiomas disponibles
Technical
Service
Pointer
❏ Page 2
® Registered trademark of Whirlpool, U.S.A., KitchenAid, U.S.A., Jenn-Air, U.S.A., or Maytag Properties, LLC or its related companies.
For Immediate Attention of Your Service Department
Technical Service Pointer #: W11378591
Action Required: Mandatory
Release Date: August, 2019
To add seal:
1. Unplug dryer or disconnect power.
2. Remove the top panel, console, front panel, belt and drum to access the
blower assembly. Refer to Service Manual W11169659 for instruction.
3. Using a 1/4" nut driver, remove the one (1) hex-head screw securing blower
wheel collar to blower housing.
4. Remove the blower housing collar and flip it over.
5. Install seal W11373810 along the outer perimeter ring by peeling from the
wax sheet and applying glue-side down on the collar as shown in Figure 2.
Use the locating features on the collar and seal for correct placement.
6. Reinstall the collar using the tab and screw. Reinstall the drum, belt, front
panel, console, and top panel.
7. Plug in dryer or reconnect power. Start cycle to confirm reduction of noise.
© 2018 All rights reserved.
Laundry Products
Publicidad
