Possible Misuse - Hilti DWS 225 Manual De Instrucciones Original

▶ After installing the backing pad, always install the screw cap.
▶ Check the power tool, the backing pad, the supply cord and the connections at regular intervals for wear.
▶ Check the power tool's supply cord at regular intervals and have it replaced by a qualified specialist if
found to be damaged.
▶ Check extension cords at regular intervals and replace them if found to be damaged. Do not touch the
supply cord or extension cord if it is damaged while working. Unplug the supply cord from the power
outlet.
▶ In the event of an interruption in the electricity supply, switch the power tool off and unplug it from the
power outlet to prevent an unwanted restart when power is restored.
3 Description
3.1 Product overview
3.2 Intended use
The product is a hand-held, electrically powered random orbital sander. It is suitable for dry-sanding wood,
wood-based materials, composites, varnishes, paints, plastics, plaster and filler compounds with wearing,
replaceable sanding pads.
3.3

Possible misuse

• This product is not suitable for working on hazardous materials.
• This product is not suitable for working in a damp environment and use of the product for wet sanding is
prohibited.
• Do not use backing pads with a nominal working speed lower than 8000 rpm.
3.4 LED indicators on the control panel
On the control panel there is a multi-purpose LED to indicate operating status or malfunction of the power
tool, and an LED array for indicating speed (rpm).
Status
A: Multi-purpose LED shows green
B: Multi-purpose LED shows green
C: Multi-purpose LED flashes green/red
D: Multi-purpose LED shows red
D: Multi-purpose LED quick-flashes green/red
*2301586*
1
2
2301586
Sanding head
@
Extractor
;
Grip surfaces
=
Control panel
%
Power cord socket
&
Hose connector
(
Backing pad
)
Multi-purpose LED
+
On/off button
§
Speed indicator
/
Increase/reduce speed
:
Start/stop button
∙
Meaning
AC supply connected.
Power tool switched on and/or start/stop button
pressed, speed indicator active.
Speed is increased/reduced; selected speed is
indicated by the LEDs.
Overtemperature warning.
Voltage outside appropriate range.
English 13