Reer Auto-Close Manual Del Usuario página 13

Step 3
Pull out the adjustment screw on the upper side of the door gate on the hinge side Ill. 13 until the
distance between the wall and the gate frame is identical at the top and the bottom Ill. 14.
(The vertical rod of the door gate frame is equipped with a slight angle deviation in order to fit the
door gate in the mounting opening under tension), Ill. 15.
Pull the adjustment screw at the top on the closure side of the gate until Ill. 12 the distance
between the frame end cap of the frame and the handle mechanism is 3 - 4 mm, Ill. 16.
After tightening, check to ensure that the distance from the middle rod to the attachment surface
is the same so that the rod is vertical, Ill. 17.
Opening /Closing In order to open the door, press the release button of the closure lightly and push it back until the
the gate metal closure bolt withdraws from the bolt opening of the frame casing, Ill. 18.
To open, lift the gate element slightly. After passing, let go of the door. It swings back from any
position and closes automatically.
Green indicator: Door securely closed, Ill. 19.
Red indicator: Danger – door not locked! Ill. 20.
When passed, ensure that the display is green.
Installation on stairs
ATTENTION!
Always open the gate away from the dangerous position! In order to limit the opening
direction, installation of the stopper is optional.
(A)
(A) If the safety barrier is used at the bottom of the stairs, it
should be positioned in the front of the lowest tread possible.
Installation of the extensions
(max. 6 pieces)
Remove adjusting screws (e) and (f) and attach the extension part(s) to each side of the safety
gate. Insert the adjusting screws into the extension(s). Ill. 21
Usage When using several extension parts, divide them equally between the two gate sides, Ill. 22.
of several Never use the extensions only on one side! Ill. 23
extensions
Interlock the extensions. Insert the adjusting screws (e) and (f) into the last segment. Continue to
assemble as described on page 10.
The fluorescent light rail Night-Safe that is glued to the bottom of the frame ensures safety in the
dark. 30 minutes of daylight power it for 9 - 12 hours.
- 11 -