Installation - Glacier bay FW6AC012CP Guía De Instalación Y Cuidado

Installation

1
Installing the faucet assembly
CAUTION: Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply. Remove the old
faucet.
□
Clean the mounting surface.
□
Place the faucet (A) through the mounting
holes in the sink.
□
Ensure the slot openings of the rubber
spacer (G) and metal spacer (H) face toward
the rear of the sink.
□
Secure the faucet (A) to the sink using the
lock nut (I) provided.
A
G
H
I
2
A
G
H
I
I
4
Installing the faucet handles
□
Remove the preassembled guide washers (E),
metal washers (D) and rubber washers (C) from
the hot and cold faucet handles (B and K).
□
Loosen the screws on the guide washers (E) until
the ends of the screws are flush with the face of
the guide washers (E).
□
Insert the hot faucet handle (B) to the left of the
spout and cold faucet handle (K) to the right of
the spout.
□
Attach the faucet handles (B and K) under-neath
the sink using the rubber washers (C), metal
washers (D) and guide washers (E). Securely
tighten the screws on the guide washers (E).
B
B
C
D
E
E
K
K
E