Description; Intended Use; Overview; Safety - GreenWorks GTL9526 Manual Del Operario

EN
1

DESCRIPTION

1.1

INTENDED USE

The battery-powered cultivator is intended for loosening of
soil in an open garden area. This product is not intended for
commercial use.
1.2

OVERVIEW

Figure 1-6
Upper handle
1
Lower handle
2
Wing nut
3
Bail switch
4
Safety lock button
5
Wheel assembly
6
Ring pin
7
2

SAFETY

Make sure that you do/obey all safety instructions.
Refer to Safety Manual.
3

INSTALLATION

Do not change or make accessories that are not
recommended by the manufacturer.
Do not connect the machine to the power supply until you
assemble all the parts.
3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If the parts are damaged, do not use the machine.
• If you do not have all the parts, do not operate the
machine.
• If the parts are damaged or missing, speak to the service
center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
Tine A
8
Tine B
9
Tine C
10
Tine D
11
Hitch pin
12
Felt
13
Plug connector
14
WARNING
WARNING
WARNING
WARNING
WARNING
English
4. Remove the machine from the box.
5. Discard the box and package in compliance with local
regulations.
3.1.1 INSTALL THE HANDLE
Figure 2.
1. Align the holes on the upper handle with holes on the
lower.
2. Insert the bolts through the handles.
3. Use the wing nuts to tighten them.
3.1.2 INSTALL THE WHEEL
Figure 3.
1. Insert the wheel assembly into the support rod.
2. Align the wheel assembly hole to desired position.
3. Slide bolt through hole and attach hitch pin to bolt.
The wheel position of the machine is adjustable.You can
control the depth of operation through adjusting the wheel
position.
Wheels can be removed for greater tilling depth.
3.1.3 INSTALL THE TINES
Figure 6.
The cultivator has four tines —two inner tines stamped B and
C and two outer tines stamped A and D. For correct operation
of the unit, the tines must be installed in the correct
orientation.
1. Put the machine on a flat and smooth surface.
2. Place tine C on the tine shaft to the left of the gear box.
The stamped side of the tine should face away from the
gear box.
3. Place tine B on the tine shaft to the right of the gear box.
The stamped side of the tine should face away from the
gear box.
4. Place a felt washer on each side of the tine shaft, and
slide to rest against the inner tines.
5. Place the outer tine D on the left side of the tine shaft.
The stamped side should face in toward tine C.
6. Place the outer tine A on the right side of the tine shaft.
The stamped side should face in toward tine B.
7. To secure the tines to the tine shaft, insert the ring pins
into the holes located on either side of the tine shaft.
The unit will not operate properly if the tines are installed
incorrectly. If you notice a problem with the cultivating
operation of the unit, check for proper tine positioning.
4
NOTE
NOTE
NOTE