Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
LOADING THE BIKE(S)
Determine the appropriate setting for the wheel hook assemblies by measuring the "center to center" distance of
7.
the bike wheels. (Figure 4)
Adjust the wheel hook assemblies to match the "center to center" bike wheel distance by inserting them into the
8.
closest hole in the arm support. (Figure 5)
9.
Firmly tighten the t knobs to secure wheel hook in position.
10.
Load the largest bike first on the vehicle side using the lower wheel hooks. (Figure 6)
11.
Start with front wheel, and hang from wheel hook as shown in Figure 6.
12.
Then mount the rear wheel on the opposite hook.
13.
Secure both wheels by firmly attaching the rubber strap. (Figure 6)
14.
Use two (2) Hook & Loop straps to hold the bike frame to the bike carrier arm supports as shown.
15.
Load the second bike so that the handle bars are in the opposite direction of the first bike.
Repeat steps 11, 12, 13 and 14
CENTER TO CENTER
DISTANCE – BIKE WHEEL
FIG. 4
RUBBER STRAP
HOOK & LOOP STRAP
Cequent Consumer Products, Inc.
29000-2 Aurora Road
Solon, OH 44139
Technical Service: (800) 234-6992
ITEM:
DESCRIPTION:
.
FIG. 6
13751 & 13900
Sportwing 2 Bike Rack
CENTER TO CENTER
DISTANCE - WHEEL HOOK
WHEEL HOOK ASSEMBLY
VEHICLE SIDE
ARM SUPPORT
FIG. 5
RUBBER STRAP
HOOK & LOOP STRAP
3392900
Rev G 8-5-14
Publicidad
Tabla de contenido
